How do you install a side spray kitchen faucet?

Turn Off Water

1. Turn Off Water.
2. Connect Supply Lines to Faucet.
3. Apply Sealant and Position Faucet.
4. Screw on Mounting Nuts.
5. Connect Supply Lines to Shut off Valves.
6. Apply Sealant to Sprayer Base.
7. Screw in Mounting Nuts.
8. Screw in the Sprayer Hose.

Can you install a faucet without the plate?

You can install units with or without deck plates in three-hole sinks. Four or five holes – Sinks with more holes allow you flexibility during installation. Install a single or double-handle faucet and use the remaining holes for accessories.

How do I adjust a single handle kitchen faucet?

Adjusting a Single-Handle Kitchen or Bathroom Faucet

1. Step 1: Turn the Hot and Cold Water Valves Off. Head under the sink and turn both the hot and cold water valves off.
2. Step 2: Remove the Handle from the Faucet.
3. Step 3: Adjust the Temperature on the Valve.
4. Step 4: Replace the Handle and Test the Water Temperature.

How far should faucet be sprayer?

When measuring the spacing between faucet tailpieces or between holes in the countertop, the correct measurement is always “on-center”, from the center of one tailpiece to the center of another. The sprayer or soap dispenser should line up with the faucet.

How do you remove a Delta kitchen faucet sprayer?

Pull the sprayer out some way. Create a loop with your sprayer’s hose so that it wouldn’t go back down the faucet neck. Check whether the sprayer is connected to the head in a snap-on/ quick release connection or a threaded in connection. If quick release connection, press on the button and disconnect the sprayer head.