How To Install Kitchen Range Anchor?

Do you need an anti-tip bracket for range?

Anti-tip brackets have been required since 1991; however, concerns have been raised that, despite the brackets being made available, they require special installation procedures which homeowners and/or installers may disregard.

What is an anti-tip bracket on a stove?

Anti-tip brackets are metal devices designed to prevent freestanding ranges from tipping. They are normally attached to a rear leg of the range or screwed into the wall behind the range, and are included in all installation kits.

How much does it cost to install an anti tip bracket on a stove?

If you cannot install the device yourself, contact an appliance repair firm or local handyman to arrange for an installation. The cost usually ranges (no pun intended) from $50 to $125.

Why do you need anti-tip bracket for stove?

An anti-tip bracket is a small metal bracket that is attached to the rear of a range to prevent it from tipping over. Anti-tip brackets became a requirement to be sold with new ranges in 1991 due to injuries resulting from ranges tipping over and causing significant injury and death.

How often do stoves tip over?

Tip-over accidents occur in most rooms in the home, but only 4% occur in kitchens. That’s compared to 45% in bedrooms, 24% in living rooms and 29% in other areas of the home. Range-tipping is easily prevented, and taking right measures can reduce the risk to almost zero.

You might be interested:  Readers ask: How To Install Gfci Outlet In Kitchen?

Can a stove tip over?

Approximately 15 to 20 million kitchens in the United States are equipped with a range that can tip over and crush, scald or burn whoever is standing in front of it.

How do you test an anti-tip bracket?

Verify Anti-Tip Bracket Is Installed and Engaged:

  1. Remove the storage drawer. See “Storage Drawer” section.
  2. Use a flashlight to look underneath the bottom of the range.
  3. Visually check that the rear range foot is inserted into the slot of the anti-tip bracket.

How do you push back a stove?

Pull your stove out from the wall and clean floor, etc. When ready to push stove back into place, spray Pledge or an equal where the feet of the stove will slide. This will keep your floor from ripping or scratching.

Leave a Reply

Your email address will not be published. Required fields are marked *

Releated

Readers ask: How To Install A Moen Kitchen Faucet With A Sprayer?

Contents1 How do you remove a Moen faucet sprayer hose?2 Do you have to use plumbers putty when installing a new faucet?3 How do you change a Moen sprayer hose?4 Can I use silicone in place of plumbers putty?5 Do I need Teflon tape on faucet supply lines?6 Should you caulk around faucet?7 How do […]

How To Install Kitchen Curtain Rods?

Contents1 Where should curtain rod brackets be placed?2 How far apart should curtain rod brackets be?3 Do curtain rods need studs?4 How high should you hang a curtain rod above the window?5 How much should a curtain pole overhang?6 How wide can a curtain rod be without support?7 How high should a curtain rod be […]