Often asked: How Do I Install Kitchen Cabinet Handles?

What size drill bit do I need for cabinet hardware?

Drill Holes Most cabinet screws need a 3/16-inch diameter hole, so use a power drill with a 3/16-inch twist bit to create the screw holes. The cabinet pull manufacturer’s instructions will specify the required drill bit size as well.

How do you straighten crooked cabinet pulls?

Push a little wood putty into each hole with your fingers. Put in enough to completely fill each hole to the surface of the cabinet, from front to back and pack it firmly by placing opposing thumbs on the front and back of the hole to squeeze it in tightly.

How can I install cabinet knobs without drilling?

Cut a piece of Command Strip to fit the knob’s base and press it into place on your cabinet front. Peel off the paper backing and firmly press your knob into place. That’s it!

Leave a Reply

Your email address will not be published. Required fields are marked *

Releated

Readers ask: How To Install A Moen Kitchen Faucet With A Sprayer?

Contents1 How do you remove a Moen faucet sprayer hose?2 Do you have to use plumbers putty when installing a new faucet?3 How do you change a Moen sprayer hose?4 Can I use silicone in place of plumbers putty?5 Do I need Teflon tape on faucet supply lines?6 Should you caulk around faucet?7 How do […]

How To Install Kitchen Curtain Rods?

Contents1 Where should curtain rod brackets be placed?2 How far apart should curtain rod brackets be?3 Do curtain rods need studs?4 How high should you hang a curtain rod above the window?5 How much should a curtain pole overhang?6 How wide can a curtain rod be without support?7 How high should a curtain rod be […]