Often asked: How To Install Kitchen Pulls?

Where should Pulls be placed on kitchen cabinets?

For both upper and lower cabinets, the pulls should be installed vertically 2 ½ – 3 inches in from the corner of the door. For drawers, they should be installed horizontally in the center of the door. While there is no hard-set rule for the size of your pulls, consider using longer ones on larger drawers and cabinets.

How wide should drawer pulls be?

Determine Size While there is no set rule, we generally recommend that the pull length is approximately 1/3 of the cabinet or drawer width. Small Drawers that are 12” or less typically work best with a pull that is 3” to 4” long or a knob that is 1” in diameter.

How do you install drawer pulls evenly?

Most drawer pulls are centered on the drawer fronts, but if the cabinet you’re working on has two or three drawers the same size and one larger one at the bottom, install the bottom knob (or pull) higher than the center of that drawer front. Install it so all the knobs on the cabinet are spaced evenly.

How do you install kitchen drawer handles?

Cabinet knobs are placed opposite of door hinges. On wall cabinets, knobs are usually placed 2-1/2” to 3” from the bottom corner of the door. On base cabinets, they are placed 2-1/2” to 3” from the upper corner of the door. If your drawer is 24” or wider, you may choose to place a second knob.

You might be interested:  How To Install Caulk In Kitchen With Invisible Glass?

How do I install knobs without drilling?

Cut a piece of Command Strip to fit the knob’s base and press it into place on your cabinet front. Peel off the paper backing and firmly press your knob into place. That’s it!

What size drill bit do I need for cabinet hardware?

The majority of cabinet knobs are packaged with #8 machine screws, which measure 0.16 inch, or roughly 5/32 inch, in diameter. Use a 3/16-inch bit to drill the hole. The screw should fit through the hole without binding.

Leave a Reply

Your email address will not be published. Required fields are marked *

Releated

Readers ask: How To Install A Moen Kitchen Faucet With A Sprayer?

Contents1 How do you remove a Moen faucet sprayer hose?2 Do you have to use plumbers putty when installing a new faucet?3 How do you change a Moen sprayer hose?4 Can I use silicone in place of plumbers putty?5 Do I need Teflon tape on faucet supply lines?6 Should you caulk around faucet?7 How do […]

How To Install Kitchen Curtain Rods?

Contents1 Where should curtain rod brackets be placed?2 How far apart should curtain rod brackets be?3 Do curtain rods need studs?4 How high should you hang a curtain rod above the window?5 How much should a curtain pole overhang?6 How wide can a curtain rod be without support?7 How high should a curtain rod be […]