Question: How To Install New Kitchen Drawer Hardware?
Contents
How do you replace drawer pulls?
Simply grab a screwdriver (don’t use an electric drill) and carefully remove the screw from the backside of the drawer or cabinet. If your knob or pull doesn’t have a screw, look for a nut and washer; unscrew the nut and slide off the washer, and pull the knob out from the front of the drawer.
How do you install knobs without drilling cabinets?
Cut a piece of Command Strip to fit the knob’s base and press it into place on your cabinet front. Peel off the paper backing and firmly press your knob into place. That’s it!
What size drill bit do I need for cabinet hardware?
Drill Holes Most cabinet screws need a 3/16-inch diameter hole, so use a power drill with a 3/16-inch twist bit to create the screw holes. The cabinet pull manufacturer’s instructions will specify the required drill bit size as well.
How do you install drawer pulls evenly?
Most drawer pulls are centered on the drawer fronts, but if the cabinet you’re working on has two or three drawers the same size and one larger one at the bottom, install the bottom knob (or pull) higher than the center of that drawer front. Install it so all the knobs on the cabinet are spaced evenly.
Where do you place the knobs on kitchen cabinets?
Cabinet knobs are placed opposite of door hinges. On wall cabinets, knobs are usually placed 2-1/2” to 3” from the bottom corner of the door. On base cabinets, they are placed 2-1/2” to 3” from the upper corner of the door. If your drawer is 24” or wider, you may choose to place a second knob.