Quick Answer: How To Install Drain In Kitchen Sink?

Do you have to use plumbers putty when installing a new drain?

The putty will help the upper part of the drain assembly seal against the sink drain opening. If you do not have plumber’s putty or cannot use it on your type of sink, then you can use silicone or even the foam or rubber gasket that comes with some pop-up assemblies.

What’s better plumbers putty or silicone?

Both plumber’s putty and silicone are sealing compounds designed to provide a water tight fit for pop up drains, sink strainers, undersides of fittings, showers and drains. Plumber’s putty is more traditional while silicone caulking is a more modern product, but either one (in most cases) can get the job done.

Why use plumbers putty on sink drain?

It is commonly used when installing bathroom sink drains, and provides a leak-proof seal that can last several years. Plumber’s putty stays soft for a long time, making it easy to remove the drain and make corrections, if necessary.

Can a sink drain go straight down?

In a sense, all drains go through the floor. You cannot have a code-approved sink drain going down, unless you have a vent going up.

You might be interested:  Quick Answer: How To Install A Kitchen Sink Drain With Dishwasher?

How do you seal a kitchen sink drain?

Just follow these steps to put a seal around a kitchen sink.

  1. Remove old sealant. Scrape it off with a putty knife or cutting tool.
  2. Clean the area. Avoid exposing the surface to water.
  3. Prepare the silicone sealant.
  4. Apply the sealant.
  5. Smooth the sealant.
  6. Remove excess sealant.
  7. Wait for the sealant to dry.

When should you not use plumbers putty?

Do not use plumber’s putty where you need adhesive strength (to bond materials or prevent them from moving) or where you need a watertight seal in exposed areas.

Should I use plumbers putty or rubber gasket sink drain?

Even though plumber’s putty is a cheaper alternate, it is advised to use the rubber gasket. Plumber’s putty consists of chemicals and oils that stain the marble and granite, might as well crack, or erode the surface if it left on it.

Is it normal to have a small ring of standing water at sink?

Depending on how the sink was molded, the drain assembly and how much putty you used under the drain flange this could be normal. Quote: Depending on how the sink was molded, the drain assembly and how much putty you used under the drain flange this could be normal.

Leave a Reply

Your email address will not be published. Required fields are marked *

Releated

Readers ask: How To Install A Moen Kitchen Faucet With A Sprayer?

Contents1 How do you remove a Moen faucet sprayer hose?2 Do you have to use plumbers putty when installing a new faucet?3 How do you change a Moen sprayer hose?4 Can I use silicone in place of plumbers putty?5 Do I need Teflon tape on faucet supply lines?6 Should you caulk around faucet?7 How do […]

How To Install Kitchen Curtain Rods?

Contents1 Where should curtain rod brackets be placed?2 How far apart should curtain rod brackets be?3 Do curtain rods need studs?4 How high should you hang a curtain rod above the window?5 How much should a curtain pole overhang?6 How wide can a curtain rod be without support?7 How high should a curtain rod be […]