Are kitchen sink strainers necessary?

In the kitchen, screen strainers are very useful. They prevent the loss of small items listed above, but also prevent large pits, small plastic kitchen items, cocktail forks and knives, shot gasses, small jar lids, etc…from ending up in the garbage disposal.

What is a kitchen sink flange?

The flange in a kitchen sink is designed to create a watertight seal between the sink and the plumbing beneath it. The seal gets exposed to dramatic fluctuations in water temperature, and over time it will eventually break down. Fortunately, repairing a leaky kitchen sink flange can be accomplished in one afternoon.

How do you measure a sink strainer?

How to Measure a Sink Drain Opening for a Crumb Cup

1. Measure the drain opening across its widest part. This gives you the diameter of the drain circle.
2. Insert the end of the measuring tape into the drain, beside the edge.
3. Note the measurements on a piece of paper and take them with you when you shop for a crumb cup.

Are kitchen sink basket strainers a standard size?

Kitchen sink basket strainers are the same size. The basket assembly can fit the sink drain opening every time. You don’t have to measure it, you don’t have to measure the size of your sink drain hole, this is the standard in the industry.

What size drain strainer do I need?

Don’t worry whether the strainer can fit your sink drain or not. The standard drain opening size is 3-1/2”, and some are 4”. This deep cup strainer can cover from 3-1/2” to 4” drain openings. If you are still concerned about the size, measure the diameter of your sink drain opening like below.

What’s better plumbers putty or silicone?

Both plumber’s putty and silicone are sealing compounds designed to provide a water tight fit for pop up drains, sink strainers, undersides of fittings, showers and drains. Plumber’s putty is more traditional while silicone caulking is a more modern product, but either one (in most cases) can get the job done.

What size are kitchen sink strainers?

A 2-inch sink strainer fits the standard bar sink drain. Drains connect to either a 1 1/4-inch or 1-1/2 inch tail pipe. These drains, like bathroom and kitchen drains, use a P-trap, which is a J-shaped pipe that connects to the main drain line.